![]() One of the main benefits of using a flux remover is that it neutralizes the acid in the flux. Do not worry too much about getting all of it outside of the joints between the solder and glass, as the next step of rinsing out with warm water will help dislodge anything stuck there. Once the flux remover has been lightly scrubbed into the glass and solder joints, wiping it away should be a simple process. This helps too if any of the flux does not come off quickly with the damp sponge. If you are looking to clean the entire piece, solder and all, then scrubbing with a soft brush is also a good idea. Depending on the specific flux residue remover you choose, the general cleaning process for glass is as follows: The oils from extra flux seeping out can damage the stained glass finish and are generally unsightly, so removing it is always a good idea. Water solubility is essential for cleaning off the flux remover at the end. The non-toxicity will allow the flux remover to be used on the glass multiple times without the worry of damaging it. Specifically look for ones that are non-toxic and water-soluble. ![]() If you are creating lots of projects, you can also find it available in larger sizes. Most flux removers should be used once before and once after applying any patina, but it is a beneficial cleaner at any stage of the process.Īlthough there are a few different flux removers around, and some are likely available at a local hobby store, many companies and people swear by CJ’s Flux Remover. Using a flux residue remover removes the oily substance from the glass and helps prevent discoloration and oxidation over time. Any excess that has seeped onto the glass may present issues for proper cleaning using other methods. Flux is an essential part of soldering to get a great hold and solder, but can quickly become frustrating to deal with. One of the best possible ways to clean stained glass after the soldering process is complete is by applying a specially-made flux residue remover. Use a Flux Residue Remover with a Gentle Scrub For more specific information on what to do, keep reading here. There are many tips and tricks for achieving an excellent cleaning after the soldering process, and order tends to be important to get the best results. There are many ways to clean the glass well, and others that should be avoided. Cleaning the glass is one of the most important steps to ensure that the solder attaches correctly and any patinas can be applied. “This post contains affiliate links, and I will be compensated if you make a purchase after clicking on my links.”Ĭreating a stained glass project is no easy feat, and the soldering process at the end can be stressful to get right.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |